Camshaft Position Sensor 3 -G300-, REMOVING AND INSTALLING: Removing

WARNING: This page is about a different car, the 2018 Audi S6, 2017 Audi S6, and 2016 Audi S6. However, it is still accessible from the selected car via links, so may be relevant.

-- Remove the engine cover. Refer to ENGINE COVER, REMOVING AND INSTALLING .

WARNING:

Fire hazards and risk of damage for a faulty engine cover.

The engine cover must be always be installed before the hood is closed.
The engine may neither be started nor driven without an engine cover.

-- Remove the air duct hoses by loosening the hose clamps -2-.

GWWA24-11121

Courtesy of AUDI OF AMERICA, LLC

-- Release the retainer -3- turn the air filter housing upper section -1- counter-clockwise in direction of -arrow B- and then remove it.

NOTE:

Ignore item -2 and arrow A-.

-- Loosen the clamp -1- and disconnect the hose from the EVAP canister.

GWWA20-10994

Courtesy of AUDI OF AMERICA, LLC

-- Disconnect the connector -1- from the EVAP Canister Purge Regulator Valve 1 -N80-.

GWWA15-11260

Courtesy of AUDI OF AMERICA, LLC

-- Remove the bolt -arrow-.

GWWA15-11259

Courtesy of AUDI OF AMERICA, LLC

-- Disconnect the connectors -1 and 2-.

-- Remove the bolts -arrows- and move the mount -3- and wiring harness to the side.

-- Disconnect the vacuum hose -1-.

GWWA21-10703

Courtesy of AUDI OF AMERICA, LLC

-- Remove the bolts -arrows- and then set the turbocharger vacuum pipe adjusting element aside.

NOTE:

Ignore item -2-.

-- Remove the bolt -arrow- and remove the camshaft position sensor -1-.

GWWA28-10080

Courtesy of AUDI OF AMERICA, LLC