Camshaft Position Sensor -G40-, REMOVING AND INSTALLING: Removing
WARNING: This page is about a different car, the 2018 Audi S6, 2017 Audi S6, and 2016 Audi S6. However, it is still accessible from the selected car via links, so may be relevant.
-- Remove the engine cover. Refer to ENGINE COVER, REMOVING AND INSTALLING .
WARNING:
Fire hazards and risk of damage for a faulty engine cover.
- The engine cover must be always be installed before the hood is closed.
- The engine may neither be started nor driven without an engine cover.
-- Remove the air filter. Refer to appropriate service information
-- Disconnect the connectors:
- For Ignition Coil 4 with Power Output Stage -N292-
- For Camshaft Position Sensor -G40-
-- Remove the bolt -arrow- and remove the camshaft position sensor.