Cylinder Bank 2 (Left):

WARNING: This page is about a different car, the 2018 Audi S6, 2017 Audi S6, and 2016 Audi S6. However, it is still accessible from the selected car via links, so may be relevant.

Courtesy of AUDI OF AMERICA, LLC

-- Press the left camshaft timing chain tensioner guide rails in as far as the stop using a screwdriver -1- and secure the chain tensioner with a :T40071 .

NOTE:

The toothed belt tensioner is lubricated with oil and should only be compressed slowly by applying constant pressure.

The procedure is illustrated with the camshaft installed.

Continued for Both Sides

Installation is performed in reverse order of removal, while noting the following:

-- Install the engine support and the right engine mount. Refer to RIGHT ENGINE MOUNT, REMOVING AND INSTALLING .

-- Install the wires. Refer to RELAY PANELS, FUSE PANELS AND E-BOXES and the Appropriate Wiring Diagram.

-- Install the front bumper cover. Refer to FRONT BUMPER .

-- Install the left front Knock Sensor 3 -G198-. Refer to Knock Sensor 3 -G198-, REMOVING AND INSTALLING .

-- Install the camshafts. Refer to CAMSHAFT, REMOVING AND INSTALLING .

-- Install the turbocharger. Refer to TURBOCHARGER, REMOVING AND INSTALLING .

-- Change the engine oil.

-- Replace the coolant. Refer to COOLANT, DRAINING AND FILLING .