Level Control System Solenoid -N111-, Removing And Installing: Removing
WARNING: This page does not describe the selected car, but rather 9 other vehicles, including the 2018 Audi S6, 2018 Audi A6 Quattro, 2018 Audi A6, 2017 Audi S6, and 2017 Audi A6 Quattro. However, it is still accessible from the selected car via links, so may be relevant.
NOTE:
The Level Control System Solenoid -N111- Is Located On The Air Supply Unit.
-- Remove the air supply unit. Refer to AIR SUPPLY UNIT, REMOVING AND INSTALLING .
NOTE:
Make Sure No Dirt Gets Into The Pressure Air System.
Clean The Area Before Removing Connecting Pieces For The Air Pipe Lines Or Other Components Of The Pressured Air System.
Seal Off Any Open Air Lines And Connections In The Pressure System Immediately With Plugs Or Cover Them.
-- Disconnect the connector -3- from the Level Control System Solenoid -N111- -2-.
-- Remove the bolts -1-.
-- Remove the Level Control System Solenoid -N111- -5- with the O-rings -1 and 4-, the spring -3- and the anchor -2-.
NOTE:
The O-ring -1- may still be located inside the air supply unit housing.