Tension Spring, Removing And Installing, Sedan: Notes
WARNING: This page does not describe the selected car, but rather 9 other vehicles, including the 2018 Audi S6, 2018 Audi A6 Quattro, 2018 Audi A6, 2017 Audi S6, and 2017 Audi A6 Quattro. However, it is still accessible from the selected car via links, so may be relevant.
- Gas-Filled Strut
- Disengage. Refer to GAS-FILLED STRUT, REMOVING AND INSTALLING
- Only with manual rear lid release
- Rear Lid Hinge
- Ball Stud
- No replacement part
- Ball Stud
- 21 Nm
- Cover
-- Press it onto the spring from the side.
-- Push the cover forward and lock it onto the hinge bolt.
- Spring
- Pay attention to the spring engaging direction. Refer to -item 1- Spring.