Rear Lid, Removing And Installing, AVANT: Procedure
WARNING: This page does not describe the selected car, but rather 9 other vehicles, including the 2018 Audi S6, 2018 Audi A6 Quattro, 2018 Audi A6, 2017 Audi S6, and 2017 Audi A6 Quattro. However, it is still accessible from the selected car via links, so may be relevant.
- Rear Lid
- Removing
-- Remove the rear lid trim panel. Refer to LUGGAGE COMPARTMENT TRIM PANELS
-- Disconnect the connectors and remove the hose for the rear window washer system.
-- Second person is required to support and lift lid.
-- Pull the gas-filled struts off the rear lid.
-- Remove the bolts from the left and right hinges on the rear lid.
-- Remove the rear lid.
- Install in reverse order of removal.
-- Adjust the rear lid. Refer to REAR LID, ADJUSTING .
- If the vehicle has a rearview camera, the Rearview Camera -R189- must be recalibrated. .
- For vehicles with a peripheral camera, the Rear Peripheral Camera -R246- must be recalibrated. .
- Removing
- Latch
- Cover
- Nuts
- Cover
- Adjusting Buffer
- Bolts
- Stop
- Bolt
- Bolt
- 21 Nm
- Bolt
- 30 Nm
- Rear Lid Motor 2 -V445-
- Lid Hinge
- Ball Stud
- Gas-Filled Strut
- The damper must be engaged in rear lid side.
- Push the insulation onto the ball stud while turning it gently.