Overview - Rear Lid, AVANT
WARNING: This page does not describe the selected car, but rather 9 other vehicles, including the 2018 Audi S6, 2018 Audi A6 Quattro, 2018 Audi A6, 2017 Audi S6, and 2017 Audi A6 Quattro. However, it is still accessible from the selected car via links, so may be relevant.
- Rear Lid
- Removing and Installing. Refer to REAR LID, REMOVING AND INSTALLING, AVANT .
- Latch
- Removing and Installing. Refer to LATCH, REMOVING AND INSTALLING, AVANT .
- Cover
- Nuts
- 21 Nm
- Cover
- Adjusting Buffer
- Adjusting. Refer to STOP AND ADJUSTING BUFFER, REMOVING AND INSTALLING, AVANT - Adjusting Buffer Installation Position .
- Bolts
- 8 Nm
- Stop
- Bolt
- 8 Nm
- Bolt
- 21 Nm
- Bolt
- 30 Nm
- Rear Lid Motor 2 -V445-
- Lid Hinge
- Removing and Installing. Refer to HINGES, REMOVING AND INSTALLING, AVANT .
- Ball Stud
- 21 Nm
- Gas-Filled Strut
- The damper must be engaged in rear lid side.
- Push the insulation onto the ball stud while turning it gently.