LEMON Manuals: Even more car manuals for everyone
Home >> Audi >> 2010 >> S4 Automatic DCT >> Repair and Diagnosis >> External Pages >> Different car >> Section 1024 (Exterior System (Hood & Lids - Service Information)) >> 55 Hood, Lids >> Rear Lid >> Latch, Removing And Installing >> Rear Lid Lock, Removing And Installing, Sedan >> Procedure

Rear Lid Lock, Removing And Installing, Sedan: Procedure

WARNING: This page does not describe the selected car, but rather 9 other vehicles, including the 2018 Audi S6, 2018 Audi A6 Quattro, 2018 Audi A6, 2017 Audi S6, and 2017 Audi A6 Quattro. However, it is still accessible from the selected car via links, so may be relevant.
GWWA55-10773Courtesy of AUDI OF AMERICA, LLC
  1. Cover
    • Before removing the lid trim, remove from the latch
  2. Latch
    • Before removal, remove the latch cover.
    • The rear lid lower trim panel is removed. Refer to LUGGAGE COMPARTMENT TRIM PANELS .
    • Disconnect the connector.
    • Remove nuts and remove the latch.
    • Remove the lid latch with the clip from the centering hole.
  3. Nut
    • 21 Nm
  4. Latch Cover
    • When installing, the cover must engage audibly in lid latch.
  5. Release Cable
    • Market-Specific Version
scientia non olet · About LEMON Manuals