LEMON Manuals: Even more car manuals for everyone
Home >> Audi >> 2010 >> S4 Automatic DCT >> Repair and Diagnosis >> External Pages >> Different car >> Section 1024 (Exterior System (Hood & Lids - Service Information)) >> 55 Hood, Lids >> Rear Lid >> Latch, Removing And Installing >> Latch, Removing And Installing, AVANT >> Procedure

Latch, Removing And Installing, AVANT: Procedure

WARNING: This page does not describe the selected car, but rather 9 other vehicles, including the 2018 Audi S6, 2018 Audi A6 Quattro, 2018 Audi A6, 2017 Audi S6, and 2017 Audi A6 Quattro. However, it is still accessible from the selected car via links, so may be relevant.
GWWA55-10802Courtesy of AUDI OF AMERICA, LLC
  1. Latch Cover
    • When assembling, cover must engage audibly into lid latch.
    • Mount the cover onto the lid latch.
  2. Nuts
    • 21 Nm
  3. Cover
    • Mount the cover on the lock until it audibly clicks into place.
  4. Latch

    -- Remove the cover for the lid latch.

    • Remove the rear lid trim panel. Refer to LUGGAGE COMPARTMENT TRIM PANELS

      -- Remove the cover -3-.

      -- Disconnect the connector to the lid latch.

      -- Remove the nuts -2- and then remove the lid latch.

  5. Connector
  6. Rear Lid
scientia non olet · About LEMON Manuals