LEMON Manuals: Even more car manuals for everyone
Home >> Audi >> 2010 >> S4 Automatic DCT >> Repair and Diagnosis >> External Pages >> Different car >> Section 1024 (Exterior System (Hood & Lids - Service Information)) >> 55 Hood, Lids >> Rear Lid >> Hinges, Removing And Installing >> Hinges, Removing And Installing, Sedan >> Procedure

Hinges, Removing And Installing, Sedan: Procedure

WARNING: This page does not describe the selected car, but rather 9 other vehicles, including the 2018 Audi S6, 2018 Audi A6 Quattro, 2018 Audi A6, 2017 Audi S6, and 2017 Audi A6 Quattro. However, it is still accessible from the selected car via links, so may be relevant.
GWWA55-10765Courtesy of AUDI OF AMERICA, LLC
  1. Lid Hinge
    NOTE:

    Have a second technician hold the rear lid so that it cannot fall down.

    • The luggage compartment side trim panel is removed. Refer to LUGGAGE COMPARTMENT SIDE TRIM PANEL, REMOVING AND INSTALLING .

      -- Remove the rear lid lower trim panel. Refer to Appropriate service information .

      -- Remove the nuts -3- from the rear lid first.

      -- Remove the bolts -2- from the side panel and remove the hinge.

      -- Align the with the markings when installing and then tighten the bolts and nuts to the tightening specification.

      -- Check the gap dimensions. Refer to Rear Lid Gap Dimensions .

  2. Bolt
    • 21 Nm
  3. Nut
    • 21 Nm
  4. Bracket
scientia non olet · About LEMON Manuals