LEMON Manuals: Even more car manuals for everyone
Home >> Audi >> 2010 >> S4 Automatic DCT >> Repair and Diagnosis >> External Pages >> Different car >> Section 1024 (Exterior System (Hood & Lids - Service Information)) >> 55 Hood, Lids >> Hood >> Latch Release Lever, Removing And Installing >> Release Lever, Removing And Installing

Release Lever, Removing And Installing

WARNING: This page does not describe the selected car, but rather 9 other vehicles, including the 2018 Audi S6, 2018 Audi A6 Quattro, 2018 Audi A6, 2017 Audi S6, and 2017 Audi A6 Quattro. However, it is still accessible from the selected car via links, so may be relevant.
GWWA55-10711Courtesy of AUDI OF AMERICA, LLC
  1. Operating Lever Mounting Bracket
    • The operating lever cover is removed.
    • The trim panel for the >>lower A-pillar is removed<<.
    • Remove the bolts -3- and disengage the cable -1-.
  2. Clip
  3. Release Cable
    • Clip the cable bracket into the mounting bracket as shown in the magnified section of the illustration.
  4. Bolts
    • 2 Nm
scientia non olet · About LEMON Manuals