LEMON Manuals: Even more car manuals for everyone
Home >> Audi >> 2010 >> S4 Automatic DCT >> Repair and Diagnosis >> External Pages >> Different car >> Section 1024 (Exterior System (Hood & Lids - Service Information)) >> 55 Hood, Lids >> Hood >> Hinges, Removing And Installing >> Procedure

Hinges, Removing And Installing: Procedure

WARNING: This page does not describe the selected car, but rather 9 other vehicles, including the 2018 Audi S6, 2018 Audi A6 Quattro, 2018 Audi A6, 2017 Audi S6, and 2017 Audi A6 Quattro. However, it is still accessible from the selected car via links, so may be relevant.
GWWA55-10752Courtesy of AUDI OF AMERICA, LLC
  1. Hood
  2. Hood Hinge
    • Removing

      -- Before removing a hood hinge, support the hood or secure it against falling.

      -- Remove the gas-filled strut. Refer to GAS-FILLED STRUT, REMOVING AND INSTALLING .

      -- Remove the bolts -4- and nuts -5-.

    • Installing

      -- Align with the markings -arrows- in reverse order.

  3. Gas-Filled Strut
  4. Cover
    • Clipped into the hinge on the side
  5. Fender Flange
  6. Bolt
    • 21 Nm
  7. Nut
    • 21 Nm
scientia non olet · About LEMON Manuals