LEMON Manuals: Even more car manuals for everyone
Home >> Audi >> 2010 >> S4 Automatic DCT >> Repair and Diagnosis >> External Pages >> Different car >> Section 1024 (Exterior System (Hood & Lids - Service Information)) >> 55 Hood, Lids >> Hood >> Gas-Filled Strut, Removing And Installing >> Installing

Gas-Filled Strut, Removing And Installing: Installing

WARNING: This page does not describe the selected car, but rather 9 other vehicles, including the 2018 Audi S6, 2018 Audi A6 Quattro, 2018 Audi A6, 2017 Audi S6, and 2017 Audi A6 Quattro. However, it is still accessible from the selected car via links, so may be relevant.
NOTE:

After complete removal of the gas-filled strut ensure correct positioning during installation: the gas-filled strut tube must be attached on the lid side.

-- Press gas-filled strut onto ball stud and engage.

scientia non olet · About LEMON Manuals