Removing the Ignition Coils from Cylinder Bank 2
WARNING: This page does not describe the selected car, but rather 9 other vehicles, including the 2018 Audi S6, 2018 Audi A6 Quattro, 2018 Audi A6, 2017 Audi S6, and 2017 Audi A6 Quattro. However, it is still accessible from the selected car via links, so may be relevant.
-- Disconnect the connector -1- from the Engine Coolant Level Warning Switch -F66- on the bottom of the coolant reservoir and then move the coolant reservoir to the side with the coolant hoses -arrows- still connected.
-- Remove the bolt -2- from the coolant reservoir.
-- Remove the screws -arrows- and disconnect the connectors on the ignition coils.
-- Move the wiring harness slightly down.
Continuation for Both Sides:
-- Remove the ignition coils using the Puller:T40039 -arrow-.
-- Remove spark plugs using Spark Plug Wrench:3122B .