LEMON Manuals: Even more car manuals for everyone
Home >> Audi >> 2010 >> S4 Automatic DCT >> Repair and Diagnosis >> External Pages >> Different car >> Section 1023 (General Maintenance (1 Of 2)) >> Maintenance >> General Information >> Tow Starting/Towing

Tow Starting/Towing

WARNING: This page does not describe the selected car, but rather 9 other vehicles, including the 2018 Audi S6, 2018 Audi A6 Quattro, 2018 Audi A6, 2017 Audi S6, and 2017 Audi A6 Quattro. However, it is still accessible from the selected car via links, so may be relevant.

-- Attach tow rope or bar only at following eyes:

GWWA63-10614Courtesy of AUDI OF AMERICA, LLC
GWWA63-10615Courtesy of AUDI OF AMERICA, LLC
NOTE:

Depending on the vehicle equipment level, there are covers!

-- The cover lifts off the bumper when pressed lightly -arrow-.

-- Remove towing eye from vehicle tool kit compartment.

-- Screw in towing eye until stop and tighten eye with wheel bolt wrench.

-- Remove towing eye after use and return to vehicle tool kit storage compartment. Towing eye must always be in vehicle.

NOTE:

The tow rope should be able to stretch to reduce the risk of damage to both vehicles. Therefore only ropes of synthetic material or rope from similarly flexible material should be used. However it is safer to use a tow bar!

Avoid excessive towing effort and do not jerk. During towing operations on unpaved roads there is always a danger that the attachment points will be overstressed and damaged.

Vehicle towing should only be done if it is not possible to start the engine with the starting assist cable.

If the vehicle must ever tow or be towed, observe the following: 

When towing vehicles with manual transmission, observe the following: 

-- Switch into 2nd or 3rd gear, press the clutch pedal and hold it before tow starting.

-- Switch on the ignition.

-- When both vehicles are in motion, release the clutch pedal.

-- As soon as the engine is started, push in the clutch and take the car out of gear to avoid running into the towing vehicle.

NOTE:

Vehicles with catalytic converter (gasoline engine only) must not be started when the catalytic converter is at operating temperature and pulling the vehicle over a longer distance of more than 50 m. Otherwise, the vehicle could be damaged by unburned fuel entering the catalytic converter.

Tow starting of vehicles with automatic transmission is not possible for technical reasons.

When towing vehicles with front wheel drive and automatic transmission, observe the following:

For longer distances, the front end of the vehicle must be raised.

Reason: With engine switched off, the transmission oil pump does not work. Therefore the transmission is not sufficiently lubricated at higher speeds and longer distances.

When towing with a tow truck, the vehicle may only be towed with raised front wheels.

Reason: With car raised in the back, the driveshafts turn backwards. This would cause the planetary gears in the automatic transmission to achieve such high RPM that the transmission would be heavily damaged within a very short time.

When towing vehicles with AWD and manual transmission, also observe the following: 

The vehicle can be towed with a tow truck with the front or rear axle raised.

NOTE:

If normal towing of the vehicle is not possible, the vehicle must be transported with a special transporter or trailer. This also applies to towing distances of over 30 miles (50 km).

When towing vehicles with AWD and automatic transmission, also observe the following: 

The vehicle must not be towed by a tow truck with front or rear axle raised.

NOTE:

If normal towing of the vehicle is not possible, the vehicle must be transported with a special transporter or trailer. This also applies to towing distances of over 30 miles (50 km).