Transfer Fuel Pump -G6-, CHECKING: Assembling
WARNING: This page is about a different car, the 2016 Audi A6 Quattro. However, it is still accessible from the selected car via links, so may be relevant.
Assembly is performed in the reverse order of disassembly, noting the following:
- The ignition must be off.
NOTE:
Decrease the fuel pressure by opening the drains -B and C- and letting the fuel run into the measuring container before removing the pressure gauge -1-.
-- Remove the :VAS6551 with the connecting cables.
-- Secure the fuel supply line with a hose clamp and then pull on it to make sure the fuel supply line is secure.