Fuel Pump Control Module -J538-, REMOVING AND INSTALLING: Removing: Notes
WARNING: This page is about a different car, the 2016 Audi A6 Quattro. However, it is still accessible from the selected car via links, so may be relevant.
-- Follow all safety precautions. Refer to SAFETY PRECAUTIONS .
-- Follow the guidelines for clean working conditions. Refer to CLEAN WORKING CONDITIONS .
CAUTION:
Risk of damaging electronic components when disconnecting the battery.
- Complete the steps for disconnecting the battery.
-- Disconnect the Ground (GND) cable from the battery terminal. Refer to BATTERY .
WARNING:
Risk of accident due to the weight of the fuel tank.
- The fuel tank must be empty when it is lowered.
-- Drain the fuel tank. Refer to FUEL TANK, DRAINING .
-- Remove the right rear wheel housing liner. Refer to REAR WHEEL HOUSING LINER, REMOVING AND INSTALLING .
Vehicles without A Selective Catalytic Reduction (SCR) System
-- Remove fuel filler tube bolts -1 and 2-.