Overview - Wheel Bearing, Fwd Vehicles Except E-Tron
WARNING: This page does not describe the selected car, but rather 9 other vehicles, including the 2018 Audi S6, 2018 Audi A6 Quattro, 2018 Audi A6, 2017 Audi S6, and 2017 Audi A6 Quattro. However, it is still accessible from the selected car via links, so may be relevant.
- Bolt
- 10 Nm
- Cover Plate
- For the brake rotor
- Bonded Rubber Bushing
- Always Replace. Refer to WHEEL BEARING HOUSING BONDED RUBBER BUSHING, REPLACING, AWD VEHICLES AND E-TRON .
- Wheel Bearing Housing
- Removing and installing. Refer to WHEEL BEARING HOUSING, REMOVING AND INSTALLING, FWD VEHICLES, EXCEPT E-TRON .
- Rear Speed Sensor
- Left Rear ABS Wheel Speed Sensor -G46-
- Right Rear ABS Wheel Speed Sensor -G44-
- Bolt
- Tightening specification. .
- Front Seal
- Wheel HubCAUTION:
- Avoid contaminating with dirt and damaging the seal when setting down/storing. Refer to .
- Wheel bearing unit, removing and installing. Refer to WHEEL BEARING UNIT, REMOVING AND INSTALLING, AWD VEHICLES, EXCEPT E-TRON .
- For servicing the wheel bearing unit. Refer to WHEEL BEARING UNIT, SERVICING .
- Brake Rotor
- Bolt
- 200 Nm +180° turn
- Always replace if removed
- Follow the assembly information when loosening and tightening. Refer to DRIVE AXLE THREADED CONNECTION, LOOSENING AND TIGHTENING .
- Dust Cap
- Bolt
- Tightening specification. .
- The wheel bearing -1- must always face up.
- Always set the wheel bearing unit down on the wheel hub -2-.