Tighten the Threaded Connection between the Drive Axle and Wheel Hub
WARNING: This page does not describe the selected car, but rather 9 other vehicles, including the 2018 Audi S6, 2018 Audi A6 Quattro, 2018 Audi A6, 2017 Audi S6, and 2017 Audi A6 Quattro. However, it is still accessible from the selected car via links, so may be relevant.
-- Replace bolt -arrow-.
NOTE:
Before installing, clean the threads in the CV joint with a tap.
Wheels must not yet touch the ground to tighten the drive axle, wheel bearing may otherwise be damaged.
-- Have a second technician push the brake pedal.
-- Tighten bolt to 200 Nm.
-- Lower the vehicle onto its wheels.
-- Tighten bolt an additional 180° turn.