Upper Transverse Link, Removing And Installing: Removing
WARNING: This page does not describe the selected car, but rather 9 other vehicles, including the 2018 Audi S6, 2018 Audi A6 Quattro, 2018 Audi A6, 2017 Audi S6, and 2017 Audi A6 Quattro. However, it is still accessible from the selected car via links, so may be relevant.
-- Before starting the procedure, measure the distance from the center of the wheel to the lower edge of the wheel housing. Refer to WHEEL BEARING IN CONTROL POSITION, LIFTING VEHICLES WITH AIR SUSPENSION or WHEEL BEARING IN CURB WEIGHT, LIFTING VEHICLES WITH COIL SPRING .
-- Remove subframe. For FWD vehicles. Refer to SUBFRAME, REMOVING AND INSTALLING, FWD VEHICLES ; for AWD vehicles. Refer to SUBFRAME, REMOVING AND INSTALLING, AWD VEHICLES .
-- Mark the installed position of the adjusting bolt -2- to the wheel bearing housing.
-- Separate connections -1 and 2-.
-- Remove upper transverse link -3-.