Bearing Bushing And Guide Pin, Replacing, Steel Brakes 1LA/1LJ: Installing
WARNING: This page does not describe the selected car, but rather 9 other vehicles, including the 2018 Audi S6, 2018 Audi A6 Quattro, 2018 Audi A6, 2017 Audi S6, and 2017 Audi A6 Quattro. However, it is still accessible from the selected car via links, so may be relevant.
-- Thinly coat the guide pin with grease from the repair kit.
-- Carefully press the guide pin into the bearing bushing as far as the first groove.
-- Insert the bearing bushing into the brake caliper.
- The bearing bushing must be seated in the center of the brake caliper.
-- Push the guide pin through the bearing bushing.
- The bearing bushing must not be seated in both grooves on the guide pin.
-- Check the movement of both guide pins.
- Both guide pins must be able to slide.
-- Install the brake pads. Refer to BRAKE PADS, REMOVING AND INSTALLING, STEEL BRAKES, 1LA/1LJ .