LEMON Manuals: Even more car manuals for everyone
Home >> Audi >> 2010 >> S4 Automatic DCT >> Repair and Diagnosis >> External Pages >> Different car >> Section 1010 (Brake System (Mechanical Components - Service Information)) >> 46 Mechanical Components >> Rear Brakes >> Brake Shield, Removing And Installing >> Removing

Brake Shield, Removing And Installing: Removing

WARNING: This page does not describe the selected car, but rather 9 other vehicles, including the 2018 Audi S6, 2018 Audi A6 Quattro, 2018 Audi A6, 2017 Audi S6, and 2017 Audi A6 Quattro. However, it is still accessible from the selected car via links, so may be relevant.

-- Remove the rear brake rotor. Refer to BRAKE ROTOR, REMOVING AND INSTALLING .

FWD Vehicles:

-- Remove the wheel bearing unit. Refer to WHEEL BEARING UNIT, REMOVING AND INSTALLING .

Continuation for All Vehicles:

GWWA42-10378Courtesy of AUDI OF AMERICA, LLC

-- Remove the cover plate screws -1-.

-- Remove the cover plate -2-.

NOTE:

The illustration shows the installation position on an AWD vehicle.

scientia non olet · About LEMON Manuals