LEMON Manuals: Even more car manuals for everyone
Home >> Audi >> 2010 >> S4 Automatic DCT >> Repair and Diagnosis >> External Pages >> Different car >> Section 1010 (Brake System (Mechanical Components - Service Information)) >> 46 Mechanical Components >> Rear Brakes >> Brake Shield, Removing And Installing >> Installing

Brake Shield, Removing And Installing: Installing

WARNING: This page does not describe the selected car, but rather 9 other vehicles, including the 2018 Audi S6, 2018 Audi A6 Quattro, 2018 Audi A6, 2017 Audi S6, and 2017 Audi A6 Quattro. However, it is still accessible from the selected car via links, so may be relevant.

-- Mount the cover plate.

-- Install and tighten the cover plate bolts.

FWD Vehicles:

-- Install the wheel bearing unit. Refer to WHEEL BEARING UNIT, REMOVING AND INSTALLING .

Continuation for All Vehicles:

-- Install the rear brake rotor. Refer to BRAKE ROTOR, REMOVING AND INSTALLING .

WARNING:

Risk of accident!

  • With the vehicle stationary, firmly press the brake pedal several times so that the brake pads in the operating condition properly sit in their respective position.
  • Make sure the brakes are working correctly before driving the vehicle for the first time.
scientia non olet · About LEMON Manuals