Brake Caliper, Removing And Installing, Ceramic Brakes: Removing

WARNING: This page does not describe the selected car, but rather 9 other vehicles, including the 2018 Audi S6, 2018 Audi A6 Quattro, 2018 Audi A6, 2017 Audi S6, and 2017 Audi A6 Quattro. However, it is still accessible from the selected car via links, so may be relevant.

-- Loosen the parking brake.

-- Switch off the ignition.

NOTE:

Do not disconnect the connectors from the parking brake motors.

-- Remove the affected rear wheel, while observing the safety precautions for vehicles with ceramic brakes. Refer to WHEELS AND TIRES .

-- Free up the brake hose -2- and the wiring harness -3- from the bracket -1-.

Courtesy of AUDI OF AMERICA, LLC

-- Unclip the bracket -3- with a screwdriver -2- in direction of -arrow-.

Courtesy of AUDI OF AMERICA, LLC

-- Free up the brake pad wear indicator wire -1-.

NOTE:

Pushing on the inner brake pad lightly with pliers -1- makes it easier to remove the brake caliper from the brake rotor. To prevent damage to the paint coat on the brake caliper, place a piece of rubber -2- between the pliers and brake caliper.

Courtesy of AUDI OF AMERICA, LLC

Do not damage the brake pad wear sensor contact -3-.

-- Remove the brake carrier bolts -arrows-.

Courtesy of AUDI OF AMERICA, LLC

-- Carefully remove the brake caliper with brake carrier and brake pads installed from the brake rotor.

NOTE:

If the brake rotor is so worn that the brake caliper cannot be removed, then the parking brake must be driven back. Refer to BRAKE PADS, REMOVING AND INSTALLING, CERAMIC BRAKES .

CAUTION:

There is a risk of damaging the brake hose.

Do not let the brake caliper hang on the brake hose. Do not support the weight with the brake hose.
Replace the brake hose if damaged.

There is a risk of damaging the brake caliper piston.

Do not operate the brakes or the electromechanical parking brake when the brake caliper is removed.

-- Hang the brake caliper with the brake carrier on the body using suitable wire.