Parking Brake, Manually Loosening: Procedure
WARNING: This page does not describe the selected car, but rather 9 other vehicles, including the 2018 Audi S6, 2018 Audi A6 Quattro, 2018 Audi A6, 2017 Audi S6, and 2017 Audi A6 Quattro. However, it is still accessible from the selected car via links, so may be relevant.
NOTE:
The following progress is then performed on each stationary rear wheel
WARNING:
Risk of accident!
- Before removing the Left Parking Brake Motor -V282- / Right Parking Brake Motor -V283-, secure the vehicle from rolling away.
-- Remove the rear wheel. Refer to WHEELS AND TIRES .
-- Disconnect the connector -1-.
-- Remove both actuator bolts -1-.
WARNING:
Risk of accident!
- Before removing the Left Parking Brake Motor -V282- / Right Parking Brake Motor -V283-, secure the vehicle from rolling away.
-- Remove the parking brake motor from the brake caliper, while doing so turn the parking brake motor back and forth.
-- Turn the input shaft -A- back until the brake is loosened.
NOTE:
Install the parking brake motor after successfully eliminating the malfunction. Refer to LEFT/RIGHT PARKING BRAKE MOTOR -V282- / -V283-, REMOVING AND INSTALLING .