Left/Right Parking Brake Motor -V282- / -V283-, Removing And Installing: Removing

WARNING: This page does not describe the selected car, but rather 9 other vehicles, including the 2018 Audi S6, 2018 Audi A6 Quattro, 2018 Audi A6, 2017 Audi S6, and 2017 Audi A6 Quattro. However, it is still accessible from the selected car via links, so may be relevant.

-- Loosen the parking brake.

-- Switch off the ignition.

NOTE:

Ignition must be switched off for at least 30 seconds before disconnecting the connector.

-- Remove the affected rear wheel, while observing the safety precautions for vehicles with ceramic brakes. Refer to WHEELS AND TIRES .

NOTE:

Clean the entire area around the connector and parking brake motor/brake caliper.

-- Disconnect the connector -arrow- to the parking brake motor.

Courtesy of AUDI OF AMERICA, LLC

-- Remove both parking brake motor bolts.

Courtesy of AUDI OF AMERICA, LLC

-- Remove the parking brake motor in direction of -arrow-.

Courtesy of AUDI OF AMERICA, LLC

-- Remove sealing ring with a suitable tool.

Courtesy of AUDI OF AMERICA, LLC

NOTE:

Be careful not to damage the ring groove on the seal and the contact surface on the parking brake motor.

Do not use any tools with sharp edges.

-- Clean ring groove and contact surfaces if dirty. Only use brake cleaner.