Electromechanical Parking Brake Control Module -J540-, REMOVING AND INSTALLING: Installing
WARNING: This page does not describe the selected car, but rather 9 other vehicles, including the 2018 Audi S6, 2018 Audi A6 Quattro, 2018 Audi A6, 2017 Audi S6, and 2017 Audi A6 Quattro. However, it is still accessible from the selected car via links, so may be relevant.
-- Connect the connector -2- to the Electromechanical Parking Brake Control Module -J540-.
-- Slide the retainer on the connector back and lock it.
-- Insert the control module.
-- If equipped, install the lower frame for the control module. Refer to RELAY AND FUSE PANELS IN E-BOX, REMOVING AND INSTALLING .
-- Install the Fuse Panel F -SF-. Refer to RELAY AND FUSE PANELS IN E-BOX, REMOVING AND INSTALLING .
-- If the Electromechanical Parking Brake Control Module -J540- is being replaced, select the "Replace" function for the Electromechanical Parking Brake Control Module -J540- on the Vehicle Diagnostic Tester in Guided Functions .