LEMON Manuals: Even more car manuals for everyone
Home >> Audi >> 2010 >> S4 Automatic DCT >> Repair and Diagnosis >> External Pages >> Different car >> Section 1010 (Brake System (Mechanical Components - Service Information)) >> 46 Mechanical Components >> Front Brakes >> Brake Rotor, Replacing >> Installing

Brake Rotor, Replacing: Installing

WARNING: This page does not describe the selected car, but rather 9 other vehicles, including the 2018 Audi S6, 2018 Audi A6 Quattro, 2018 Audi A6, 2017 Audi S6, and 2017 Audi A6 Quattro. However, it is still accessible from the selected car via links, so may be relevant.
NOTE:

Only install brake rotors from the same manufacturer and with the same quality level on a single axle.

Always replace brake rotors on both sides of the axle.

Use new bolts.

-- Clean the contact surface on the wheel hub. Remove any corrosion.

-- Place the brake rotor on the hub.

NOTE:

When positioning the brake rotor, do not tilt it on the wheel hub.

-- Install the securing bolt -5- and tighten.

-- Install the brake caliper -2-.

WARNING:

Risk of accident!

  • With the vehicle stationary, firmly press the brake pedal several times so that the brake pads in the operating condition properly sit in their respective position.
  • Make sure the brakes are working correctly before driving the vehicle for the first time.
scientia non olet · About LEMON Manuals