Brake Pads, Removing And Installing, Steel Brakes, 1LF/1LL: Removing

WARNING: This page does not describe the selected car, but rather 9 other vehicles, including the 2018 Audi S6, 2018 Audi A6 Quattro, 2018 Audi A6, 2017 Audi S6, and 2017 Audi A6 Quattro. However, it is still accessible from the selected car via links, so may be relevant.

NOTE:

Label the brake pads when removing if they are going to be used again. Install in the same position, otherwise the braking effect will be uneven.

-- Remove the affected front wheel. Refer to WHEELS AND TIRES .

Courtesy of AUDI OF AMERICA, LLC

WARNING:

Risk of injury!

The balance spring -1- is tensioned. Disengage the balance spring to remove the balance spring at the same time do not damage the brake caliper paint.

-- Remove the bolt -arrow-.

-- Remove the trim -2- and the balance spring -1-.

-- Remove the contact -1- for the brake pad wear sensor from the brake pad, while being careful of the clips -2-.

Courtesy of AUDI OF AMERICA, LLC

-- Free up the wire from the brake hose -3- and the bracket -4-.

NOTE:

If the clips -2- go missing, the brake pad wear sensor must be replaced.

NOTE:

For easier removal of the brake caliper from the brake rotor, push the brake pad -2- back lightly with pliers -1-, as shown in the illustration.

Courtesy of AUDI OF AMERICA, LLC

To prevent damage to the paint coat on the brake caliper, place a piece of rubber -3- between the pliers and the brake caliper.

-- Free up the brake hose -1- from the bracket.

Courtesy of AUDI OF AMERICA, LLC

-- Remove the protective caps -arrows-.

-- Remove the guide pins -2- using the :T50036 and pull them out slightly from the brake caliper.

-- Carefully remove the brake caliper with the brake pads from the brake rotor.

CAUTION:

There is a risk of damaging the brake hose.

Do not let the brake caliper hang on the brake hose. Do not support the weight with the brake hose.
Replace the brake hose if damaged.

There is a risk of damaging the brake caliper piston.

Do not press the brake pedal when the brake caliper is removed.

-- Hang the brake caliper on the body using a suitable wire.

-- Push off and remove each of the brake pads in the center of the brake caliper.