Brake Caliper, Replacing, Steel Brakes, 1LA/1LJ/1LF/1LL/1LU/1LV And Ceramic Brakes, LN/1LW: Installing

WARNING: This page does not describe the selected car, but rather 9 other vehicles, including the 2018 Audi S6, 2018 Audi A6 Quattro, 2018 Audi A6, 2017 Audi S6, and 2017 Audi A6 Quattro. However, it is still accessible from the selected car via links, so may be relevant.

Courtesy of AUDI OF AMERICA, LLC

-- Install the brake pads. Refer to BRAKE PADS, REMOVING AND INSTALLING .

-- Install the brake hose -1- in the brake caliper and tighten.

-- Check the retaining spring -3- for damage and replace if necessary.

-- Insert the brake hose into the brackets -arrows- and connect it to the brake line by tightening the union bolt -2-.

NOTE:

Make sure the brake hose is routed correctly.

Make sure the brake hose is not blocked, bent, twisted or rubbing against the vehicle.

-- Remove the :VAG1869/2 .

-- Only bleed the brakes on the wheel from which the brake caliper and the brake hose was loosened. Refer to HYDRAULIC SYSTEM, BLEEDING .

NOTE:

It must be bled on each bleeder screw. Bleed the brake caliper with two bleed screws first on the inner screw.

NOTE:

If the brake pedal still feels "soft", completely bleed the brakes. Refer to HYDRAULIC SYSTEM, BLEEDING .

-- Install the front wheel. Refer to WHEELS AND TIRES .

WARNING:

Risk of accident!

With the vehicle stationary, firmly press the brake pedal several times so that the brake pads in the operating condition properly sit in their respective position.
Make sure the brakes are working correctly before driving the vehicle for the first time.