Brake Caliper, Replacing, 1LP: Removing
WARNING: This page does not describe the selected car, but rather 9 other vehicles, including the 2018 Audi S6, 2018 Audi A6 Quattro, 2018 Audi A6, 2017 Audi S6, and 2017 Audi A6 Quattro. However, it is still accessible from the selected car via links, so may be relevant.
-- Remove affected front wheel. Refer to WHEELS AND TIRES .
-- Insert the :VAG1869/2 between the brake pedal and driver seat. Preload the brake pedal at least 60 mm.
NOTE:
By doing this, the valves in the brake master cylinder are closed and the brake fluid reservoir does not run empty.
-- Connect the container hose to a front brake caliper bleed screw.
-- Open a brake caliper bleed screw on the front brake caliper to reduce the pressure from the brake system.
WARNING:
- Brake fluid is poisonous, and must never be siphoned by mouth under any circumstances.
- Wash off any brake fluid that comes into contact with the skin with a lot of water.
- If brake fluid comes in contact with the eyes, wash out the eye(s) and see a doctor.
-- Close the bleed screw and tighten to 13 Nm.
NOTE:
Do not remove the :VAG1869/2 .
-- Remove the brake pads.
-- Remove the brake hose -10-
-- Remove the bolts -1-.
-- Remove brake caliper -2-.