Brake Caliper, Removing And Installing, Steel Brakes, 1LA/1LJ: Removing

WARNING: This page does not describe the selected car, but rather 9 other vehicles, including the 2018 Audi S6, 2018 Audi A6 Quattro, 2018 Audi A6, 2017 Audi S6, and 2017 Audi A6 Quattro. However, it is still accessible from the selected car via links, so may be relevant.

Courtesy of AUDI OF AMERICA, LLC

-- Remove the affected front wheel. Refer to WHEELS AND TIRES .

-- Free up the wire for the brake pad wear sensor, to do so open the dust cap -2- and disengage the wire from the brake caliper arrows.

-- Remove the contact -3- for the brake pad wear sensor from the brake pad, while being careful of the clamps -1-.

NOTE:

If the clamps -1- go missing, the brake pad wear sensor must be replaced.

NOTE:

For easier removal of the brake caliper from the brake rotor, push the brake pad -2- back lightly with pliers -1-, as shown in the illustration.

Courtesy of AUDI OF AMERICA, LLC

To prevent damage to the paint coat on the brake caliper, place a piece of rubber -3- between the pliers and the brake caliper.

-- Free up the brake hose -1- from the bracket.

Courtesy of AUDI OF AMERICA, LLC

-- Remove the bolts -arrows- and carefully pull the brake caliper with the brake carrier and the installed brake pads from the brake rotor.

CAUTION:

There is a risk of damaging the brake hose.

Do not let the brake caliper hang on the brake hose. Do not support the weight with the brake hose.
Replace the brake hose if damaged.

There is a risk of damaging the brake caliper piston.

Do not press the brake pedal when the brake caliper is removed.

-- Hang the brake caliper with the brake carrier on the body using suitable wire.