Brake Caliper, Removing And Installing, 1LP: Removing

WARNING: This page does not describe the selected car, but rather 9 other vehicles, including the 2018 Audi S6, 2018 Audi A6 Quattro, 2018 Audi A6, 2017 Audi S6, and 2017 Audi A6 Quattro. However, it is still accessible from the selected car via links, so may be relevant.

-- Remove affected front wheel. Refer to WHEELS AND TIRES .

-- Unclip the brake hose from the bracket pivot bearing

-- Unclip the brake pad wear wire.

Fig 1: Exploded View Of Front Brakes (1LP)

Courtesy of AUDI OF AMERICA, LLC

-- Remove the bolts -1-.

NOTE:

Pushing the brake pads slightly back with pliers makes it easier to remove the brake caliper from the brake rotor. To avoid damaging the brake caliper, place a piece of rubber or similar material -2- between the brake caliper. Do not damage the existing brake pad wear indicator cable when doing this.

Courtesy of AUDI OF AMERICA, LLC

-- Carefully remove the brake caliper with the brake pads still installed.

NOTE:

Do not disassemble the brake caliper. Do not loosen any screws on the brake caliper.

CAUTION:

Do not let the brake caliper with the brake carrier hang on the brake hose. Do not support the weight with the brake hose.
Replace the brake hose if damaged.
Do not press the brake pedal when the brake caliper is removed.