Overview - Brake Pedal
WARNING: This page does not describe the selected car, but rather 9 other vehicles, including the 2018 Audi S6, 2018 Audi A6 Quattro, 2018 Audi A6, 2017 Audi S6, and 2017 Audi A6 Quattro. However, it is still accessible from the selected car via links, so may be relevant.
WARNING:
Risk of accident!
- The path of the brake pedal must not be shortened by extra floor mats.
NOTE:
Lubricate all bearing and contact surfaces with Grease :G 000 450 02 .
- Brake Pedal
- Disconnecting from brake booster. Refer to BRAKE PEDAL, DISCONNECTING FROM BRAKE BOOSTER .
- Connect with brake booster. Refer to BRAKE PEDAL, ATTACHING TO BRAKE BOOSTER .
- Removing and installing. Refer to BRAKE PEDAL, REMOVING AND INSTALLING .CAUTION:
If possible, leave the brake pedal stop installed; it could break the mount for the Brake Lamp Switch -F- if the brake pedal is released too quickly.
- Clamp
- Replace after removing
- Nuts
- 8 Nm
- Mounting Bracket for Pedal Assembly
- Removing and installing. Refer to MOUNTING BRACKET, REMOVING AND INSTALLING .
- Mounting Pin
- For brake pedal
- Clamp
- Replace after removing
- Brake Pedal Position Sensor -G100-
- With magnet holder
- For vehicles with a high-voltage system
- Removing and installing. Refer to BRAKE PEDAL POSITION SENSOR, REMOVING AND INSTALLING .
- Bolt
- 4.5 Nm
- Bolt
- 8 Nm
- Holds the mounting pin in place
- Brake Lamp Switch -F-
- Removing and installing. Refer to BRAKE LAMP SWITCH, REMOVING AND INSTALLING .
- Bolt
- 20 Nm
- Pedal bracket to steering column
- StopCAUTION:
If possible, leave the brake pedal stop installed; it could break the mount for the Brake Lamp Switch -F- if the brake pedal is released too quickly.
- Pedal Rubber