LEMON Manuals: Even more car manuals for everyone
Home >> Audi >> 2010 >> S4 Automatic DCT >> Repair and Diagnosis >> External Pages >> Different car >> Section 1009 (Wiper & Washer Systems (Service Information)) >> 92 Wiper/Washer Systems >> Windshield Wiper System >> Windshield Wiper, Bringing Into Service Position

Windshield Wiper, Bringing Into Service Position

WARNING: This page does not describe the selected car, but rather 9 other vehicles, including the 2018 Audi S6, 2018 Audi A6 Quattro, 2018 Audi A6, 2017 Audi S6, and 2017 Audi A6 Quattro. However, it is still accessible from the selected car via links, so may be relevant.
CAUTION:

There Is A Risk Of Damaging The Front Lid By Moving The Windshield Wipers Back Into The Home Position.

  • Do not drive a vehicle with windshield wiper arms folded up.
  • The windshield wipers automatically go back in the basic setting when the windshield wiper switch is activated or when driving faster than 6 km/h.
NOTE:

If The Windshield Wiper Motor Is To Be Run During The Procedure, The Front Lid Must Be Completely Closed, Otherwise The Power Supply To The Wiper Motor Will Be Interrupted.

-- Make sure the wiper blades are not frozen if there is a risk for frost.

-- Turn on the ignition.

-- Activate the windshield wiper "on" menu item using the multimedia system control head. Refer to the Owner's Manual.

-- Turn off the ignition.