Washer Fluid Reservoir Filler Neck, Removing And Installing: Installing
WARNING: This page does not describe the selected car, but rather 9 other vehicles, including the 2018 Audi S6, 2018 Audi A6 Quattro, 2018 Audi A6, 2017 Audi S6, and 2017 Audi A6 Quattro. However, it is still accessible from the selected car via links, so may be relevant.
Install In Reverse Order Of Removal. Note The Following:
-- Slide the grommet -2- all the way onto the filler tube for the filler neck -1-.
- The tab -3- must fit into the opening -arrow- on the filler tube.
-- Insert the filler neck into the washer fluid reservoir.
NOTE:
Make Sure The O-Ring Is Not Crushed When Sliding It Into The Washer Fluid Reservoir.