Overview - Windshield Washer System: Notes

WARNING: This page does not describe the selected car, but rather 9 other vehicles, including the 2018 Audi S6, 2018 Audi A6 Quattro, 2018 Audi A6, 2017 Audi S6, and 2017 Audi A6 Quattro. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Exploded View Of Windshield Washer Fluid Reservoir, Lines And Nozzle

Courtesy of AUDI OF AMERICA, LLC

Windshield Washer Fluid Level Sensor -G33-
- Removing and installing. Refer to WINDSHIELD WASHER FLUID LEVEL SENSOR, REMOVING AND INSTALLING .
Grommet
- Always replace if damaged.
Screw
- Tightening Sequence. Refer to Figure.
Screw
- Tightening Sequence. Refer to Figure.
Bolt
- 8 Nm
Bolt
- 8 Nm
Filler Neck
- For the washer fluid reservoir
- Removing and installing. Refer to WASHER FLUID RESERVOIR FILLER NECK, REMOVING AND INSTALLING .
Cap
- For the filler neck
Washer Fluid Hose
- For the windshield washer system
Right Washer Nozzle
- Versions with Right Washer Nozzle Heater -Z21-
- Removing and installing. Refer to WASHER NOZZLES, REMOVING AND INSTALLING .
- Adjusting. Refer to WASHER NOZZLES, ADJUSTING .
Left Washer Nozzle
- Versions with Left Washer Nozzle Heater -Z20-
- Removing and installing. Refer to WASHER NOZZLES, REMOVING AND INSTALLING .
- Adjusting. Refer to WASHER NOZZLES, ADJUSTING .
Grommet
- For the washer fluid hose in the front lid
Grommet
- For the windshield washer fluid hose on the fender
Grommet
- Always replace if damaged.
O-ring
- Always replace if damaged.
Washer Fluid Reservoir
- Removing and installing. Refer to WASHER FLUID RESERVOIR, REMOVING AND INSTALLING .
Securing Tab
- For the mount inside the fender end plate
Windshield Washer Pump -V5-
- Removing and installing. Refer to WINDSHIELD WASHER PUMP, REMOVING AND INSTALLING .
Grommet
- Always replace if damaged.