Wiper Arm, Adjusting: Procedure

WARNING: This page does not describe the selected car, but rather 9 other vehicles, including the 2018 Audi S6, 2018 Audi A6 Quattro, 2018 Audi A6, 2017 Audi S6, and 2017 Audi A6 Quattro. However, it is still accessible from the selected car via links, so may be relevant.

-- Remove the wiper arm. Refer to WINDSHIELD WIPER ARM, REMOVING AND INSTALLING .

-- Turn on the ignition.

-- Activate "rear wiping" and let the wiper arm run to end position.

-- Turn off the ignition.

-- Position the wiper arm with the wiper blade mounted on the windshield wiper axle and align the wiper blade to the rear window as follows:

Courtesy of AUDI OF AMERICA, LLC

Dimension -a- = 19 + 5 mm.

NOTE:

The Dimension Is The Distance Between The Wiper Blade Tip And The Lower Edge Of The Window.

-- Tighten the wiper arm nut.

-- Turn on the ignition.

-- Activate "rear wiping" and let the wiper arm run to end position.

-- Check the wiper arm adjustment again and correct if necessary.