Windshield Wiper Arm, Removing And Installing: Removing
WARNING: This page does not describe the selected car, but rather 9 other vehicles, including the 2018 Audi S6, 2018 Audi A6 Quattro, 2018 Audi A6, 2017 Audi S6, and 2017 Audi A6 Quattro. However, it is still accessible from the selected car via links, so may be relevant.
-- Turn on the ignition.
-- Activate "rear wiping" and let the wiper arm run to end position.
-- Turn off the ignition.
-- Vehicles with ignition lock: remove the ignition key.
-- Carefully expand the cap in direction of -arrows- and lift off.
-- Carefully remove the washer nozzle -2-.
-- Loosen the nut -1- one turn.
-- Install an M6 nut -4- on the nut.
-- Position the :T10369/5 on the wiper arm -2- as shown in the image.
-- Position the thrust piece -3- on the wiper axle.
-- Turn the bolt -1- clockwise until the wiper arm is removed from the axle.
-- Remove the nut completely and remove the wiper arm.