Evaporative Emissions (EVAP) System
WARNING: This page is about a different car, the 2006 Audi A4, 2005 Audi A4, 2004 Audi A4, 2003 Audi A4, and 2002 Audi A4. However, it is still accessible from the selected car via links, so may be relevant.
For all EVAP system component locations and hose routing. Refer to → 20 - FUEL SUPPLY SYSTEM
For the EVAP system hose routing. Refer to → 20 - FUEL SUPPLY SYSTEM
For all EVAP system removal/installation procedures and torque specifications. Refer to → 20 - FUEL SUPPLY SYSTEM
Check the Technical Bulletins for information that may supersede any information included in this article.
NOTE:
- All manufacturers special tools as well as common tools may contain a manufacturer specific part number. These tools may be substituted with an equivalent aftermarket tool or are available for purchase through Audi.
- Manufacturers special tools as well as common tools that contain a manufacturer specific part number may be referenced in the test procedure illustrations showing the tool use or installation. If the manufacturer specific tool is not being used, an equivalent aftermarket tool may be installed in the same manner as the manufacturers special tool.
- The manufacturers test box Test Box 105 Pin VAG1598/31 is available for purchase or rental.