Brake Rotor, Replacing, Brake Pads Removed: Removing

-- Raise the vehicle.

-- Remove the wheels.

-- Remove the brake hose and electrical wire from the bracket on the stub axle carrier

NOTE:

Actuator or brake system connector must not be disconnected (otherwise, a fault will be saved).

Do not pull on brake hose or electrical wiring.

-- Remove the rear brake pads. Refer to BRAKE PADS, REMOVING AND INSTALLING .

-- Remove the bolts -16 and 17- and remove the brake carrier.

Fig 1: Overview Of Rear Brake Components

Courtesy of AUDI OF AMERICA, LLC

-- Remove the bolt -arrow- while holding the brake rotor in place.

Fig 2: Identifying Brake Disc Secure Bolt

Courtesy of AUDI OF AMERICA, LLC

-- Remove the brake rotor from the wheel hub.

NOTE:

When removing the brake rotor from the wheel hub, do not tilt the brake rotor.