Seat Belt For Child Seat, Checking Child Seat Restraint Function, Market-Specific

To check function, you must install entire belt system, including side trim.

Switching Hold Function On

• Pull belt webbing out completely up to stop.

Correct Function

• Belt must retract with a chattering sound.
• If retracting process is stopped, belt cannot be pulled out anymore.

Deactivating

• Belt retraction to about 100 mm remaining.
• Hold function must switch off with a remainder of 100 mm, at the latest. Belt functions normally again.

• If the seat belt child seat anchorage does not work, replace the seat belt