All Wheel Drive Control Module -J492-, REMOVING AND INSTALLING
WARNING: This page is about a different variant/trim than selected.
NOTE:
All Wheel Drive Control Module -J492- component location. Refer to COMPONENT LOCATION OVERVIEW - TRANSMISSION CONTROL .
Removing and installing is on the A4 Sedan.
- The ignition is off.
-- Remove the luggage compartment floor covering.
-- Remove the covering and the vehicle tools mount.
-- Remove the All Wheel Drive Control Module -J492- -A- from the bracket -C-.
Fig 1: All Wheel Drive (AWD) Control Module -J492- In Audi A4 Sedan, Audi A5 Coupe And Audi A5 Cabriolet
-- Disconnect the connector -B- from the All Wheel Drive Control Module -J492-.
-- Install the All Wheel Drive Control Module -J492- in reverse order of removal.
- If the All Wheel Drive Control Module -J492- was replaced then additional work is necessary. Refer to All Wheel Drive Control Module -J492-, ADDITIONAL WORK AFTER REPLACING .