LEMON Manuals: Even more car manuals for everyone
Home >> Audi >> 2010 >> A4 2.0T >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 9 (Final Drive & Driveshaft - Rear Final Drive (Sedan) (As Of 05.2015)) >> 39 Final Drive, Driveshaft >> Seals >> Left Seal, Replacing >> Left Seal, Replacing, 0BC >> Removing

Left Seal, Replacing, 0BC: Removing

WARNING: This page is about a different variant/trim than selected.

-- Follow all general repair information. Refer to REPAIR INFORMATION .

-- Remove the rear final drive. Refer to FINAL DRIVE, REMOVING AND INSTALLING .

Remove the Right Flange Shaft

Fig 1: Removing Right Flange Shaft
GWWA39-10264Courtesy of AUDI OF AMERICA, LLC

-- Attach the Puller - Flanged Shaft T10037 to the housing -arrow- and remove the flange shaft.

Left Flange Shaft, Removing

Fig 2: Removing Left Flange Shaft
GWWA39-10263Courtesy of AUDI OF AMERICA, LLC

-- Attach the Puller - Flanged Shaft T10037 to the housing -arrow- and remove the flange shaft.

-- Use a suitable tool to pry out the seal.

Fig 3: Prying Out Sealing Ring With Suitable Lever
GWWA39-0373Courtesy of AUDI OF AMERICA, LLC