Input Shaft Seal, Replacing, 0BD: Notes
WARNING: This page is about a different variant/trim than selected.
- The flange/driveshaft used before must be installed.
- If the flange/driveshaft is also being replaced, do the following. Refer to FLANGE SHAFT RING, REPLACING, 0BD .
Special tools and workshop equipment required
- Puller - Multiple Use VW391
- Slide Hammer Set VW771
- Slide Hammer Set - Hook VW771/37
- Seal Installer - Driveshaft Flange T40112
- Retainer - Drive Flange 3028
- Seal Installer - Wheel Bearing Seal 3143
- Holding Fixture - Gearbox Adapter T10235
- Friction Gauge VAS6222
- Inductive Heater VAS6414
- Sealing Grease G 052 128 A1
- Locking Fluid AMV 185 101 A1
- Three M8 x 25 bolts
- Two M10 x 40 bolts