LEMON Manuals: Even more car manuals for everyone
Home >> Audi >> 2010 >> A4 2.0T >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 9 (Final Drive & Driveshaft - Rear Final Drive (Sedan) (As Of 05.2015)) >> 39 Final Drive, Driveshaft >> Final Drive >> Final Drive, Removing And Installing >> Additional Work After Replacing Rear Final Drive 0BE, 0BF

Additional Work After Replacing Rear Final Drive 0BE, 0BF

WARNING: This page is about a different variant/trim than selected.
WARNING:

Malfunctions on the rear final drive.

If the rear final drive was replaced, the following additional work is necessary.

  • Bleed the hydraulic control module using the Vehicle Diagnostic Tester.
  • Program the rear final drive on the All Wheel Drive Control Module -J492- use the Vehicle Diagnostic Tester.
  • The additional work can only be performed when the rear final drive is replaced.

Procedure: 

-- Connect the Vehicle Diagnostic Tester and turn on the ignition.

-- Select the function 22 - Rear Final Drive Replacing  in the vehicle diagnostic tester under Guided Functions  in the directory 22- All Wheel Drive Electronics  .

The new rear final drive is "adapted" on the All Wheel Drive Control Module -J492- using the Vehicle Diagnostic Tester.

NOTE:

A system check will take place when the function 22 - Rear Final Drive Replacing  is complete. If malfunctions appear, then use "Guided Fault Finding" to correct them.

Tightening Specification 

Component Nm
Wiring harness bracket on the rear final drive 9
scientia non olet · About LEMON Manuals