Transmission Tightening Specification, AUDI Q5: Notes
WARNING: This page is about a different variant/trim than selected.
NOTE:
The tightening specifications apply only to lightly greased, oiled, phosphated or blackened nuts and bolts.
Additional lubricant such as engine or transmission oil may be used, but do not use graphite lubricant.
Do not use any ungreased parts.
Tightening specification tolerance ± 15%.
Other tightening specifications:
| Component | Nm | ||
|---|---|---|---|
| Bolts and nuts | M6 | 9 | |
| M7 | 15 | ||
| M8 | 20 | ||
| M10 | 40 | ||
| M12 | 65 | ||
-- Tighten the heat shield bolts -arrows- to 23 Nm.