Mounting 2.0L TFSI engine on the manual transmission
WARNING: This page is about a different variant/trim than selected.
Courtesy of AUDI OF AMERICA, LLC
| Item |
Bolt |
Nm |
| 1 1) |
M10x50 2) |
65 |
| 2 3) |
M12x100 4) |
30 + 90° |
| 3 5) |
M12x75 4) |
30 + 90° |
| 4, 5 5) |
M12 x 120 4) |
30 + 90° |
| 6 |
M12x75 4) |
30 + 90° |
| 7 |
M12x100 4) |
30 + 90° |
| 8 to 10 |
M10x75 4) |
15 + 90° |
| 11 |
M12 x 50 4) |
30 + 90° |
| A |
Alignment sleeves for centering |
- Mount the auxiliary adapter
- Steel bolt - do not replace
- Also secures that starter; with an additional spacer sleeve between the starter and the transmission.
- Check if the aluminum bolts can be used again , if not, replace them.
- Also attaches the bracket for the electric wire.
|
- The aluminum bolts -2 through 10- can be used twice. Therefore, the bolts must be marked with two notches "X" made by a chisel after they have be used the first time -arrow-
.
Courtesy of AUDI OF AMERICA, LLC
- Bolts marked with an "X" may not be used again.
- There is no limit to the number of times steel bolts -1- can be used.