Mounting 2.0L TDI engine on the manual transmission

WARNING: This page is about a different variant/trim than selected.

Fig 1: Engine To Transmission Bolts And Alignment Sleeves

GWWA34-10493

Courtesy of AUDI OF AMERICA, LLC

Item	Bolt	Nm
1 ¹⁾	M10x50 ²⁾	65
2 ³⁾	M12x100 ⁴⁾	30 + 90°
3 ⁵⁾ , 6	M12x75 ⁴⁾	30 + 90°
4, 5 ⁵⁾	M12 x 120 ⁴⁾	30 + 90°
7 to 9	M10x75 ⁴⁾	15 + 90°
10	M12 x 50 ⁴⁾	30 + 90°
A	Alignment sleeves for centering
Mount the auxiliary adapter Steel bolt - do not replace Also secures that starter; with an additional spacer sleeve between the starter and the transmission. Check if the aluminum bolts can be used again, if not, replace them. (See Fig 2) Also attaches the bracket for the electric wire.

The aluminum bolts can be used twice. Therefore, the bolts must be marked with two notches "X" made by a chisel after they have be used the first time -arrow- .

Fig 2: Identifying Bolts Marked With An "X"
Courtesy of AUDI OF AMERICA, LLC
Bolts marked with an "X" may not be used again.
There is no limit to the number of times steel bolts -1- can be used.