Transmission Range Gear Recognition Switch -F208-, REMOVING AND INSTALLING: Installing

WARNING: This page is about a different variant/trim than selected.

Install in reverse order of removal. Note the following:

-- Install the Transmission Range Gear Recognition Switch -F208- in the selector shaft cover. Tightening specification. Refer to Tightening Specification .

Fig 1: Installing Connector On Transmission Range Gear Recognition Switch

Courtesy of AUDI OF AMERICA, LLC

-- Install the connector -2- on the Transmission Range Gear Recognition Switch -F208-.

NOTE:

Disregard items -1 and 3-.

-- Install the tunnel crossmember -arrows-, refer to -item 2- Bolt.

Fig 2: Identifying Tunnel Crossmember And Bolts

Courtesy of AUDI OF AMERICA, LLC

-- Assemble the exhaust system making sure it is not under stress. Refer to EXHAUST PIPES/MUFFLERS for 2.0L, engine codes CAED, CAEB, CPMB, CPMA, EXHAUST PIPES/MUFFLERS for 3.0L, engine codes CCBA, CGXC, CTUB, or EXHAUST PIPES/MUFFLERS for 3.2L, engine code CALA .

-- Install the noise insulation. Refer to OVERVIEW - NOISE INSULATION .